User Manual

Index – continued
SC4812ET BTS Optimization/ATP — CDMA LMF
Jan 2002Index-2
cable calibration, automatic, test set–up, 3-50, 3-51
Advantest R3267/R3562, 3-51
Advantest R3465, 3-50
Agilent 8935, 3-50
Agilent E4406A/E4432B, 3-51
CyberTest, 3-50
HP 8921A, 3-50
Cables Connection for 10 MHz Signal and GPIB ,
F-2, F-4
Calibrate BLO, 3-73
Calibrating Cables, 3-67
Calibrating Test Cable Setup, PCS Interface
HP83236B, F-11
Calibrating Test Equipment, 3-67
Calibration
data file calibration, BLO, 3-75
In–Service, G-15
Calibration Audit failure, 6-7
calibration data file, description of, BLO, 3-75
Cannot communicate to Communications Analyzer,
6-3
Cannot communicate to Power Meter, 6-2
Cannot Download DATA to any device card, 6-4
Cannot ENABLE device, 6-5
Cannot Log into cell–site, 6-2
Cannot perform carrier measurement, 6-9
Cannot perform Code Domain Noise Power
measurement, 6-9
Cannot perform Rho or pilot time offset
measurement, 6-8
Cannot perform Txmask measurement, 6-8
CCD, 1-19
CCP, shelf 1 – all inclusive TX ATP test outline,
primary, 4-14
CDF
site configuration, 3-2
site equipage verification, 3-3
site type and equipage data information, 2-1
CDMA
allocation diagram for the North American, cellular
telephone frequency spectrum, D-4
optimization/ATP test matrix, B-1
cdpower test, 4-11
Cell Site
equipage verification, 2-1
types configuration, 3-2
Cell Site Data File. See CDF
Cell Site Field Engineer CFE, 1-1
Channel Service Unit, 3-4
CIO, 1-19
CIO Connectors, 6-14
CLI, 1-2
Clock Sync Module. See CSM
Code Domain Power and Noise Floor Levels, 4-12
Code Domain Power/Noise, 4-11
Communication test set, rear panel, F-2, F-4
Communications System Analyzer, 1-8
Communications system analyzer , 1-8
Components Located on CIO Card, H-10
Connecting test equipment to the BTS, 3-45
Connector Functionality
Backplane, Troubleshooting, 6-13
Troubleshooting, Backplane, 6-13
Copy CAL Files From Diskette to the CBSC, 5-2
Copy CDF Files from CBSC, 3-12
Copy Files from LMF to Diskette, 5-1
Copying CAL files from CDMA LMF to the CBSC,
5-1
Copying CAL files to the CBSC, 5-2
CSM, 1-19
and LFR primary functions, 3-35
CSM frequency verification, 3-37
CSM LED Status Combinations, 6-23
Customer I/O, 1-20
CyberTest, 3-46
CyberTest Communication Analyzer, 1-8
D
DC Power Pre–test (BTS Frame), 2-7
DC Power Problems, C–CCP Backplane
Troubleshooting, 6-17
DC/DC Converter LED Status Combinations, 6-22