User Manual

Troubleshooting68P09255A57-2
Aug 2002
SC4812ET Optimization/ATP Manual Software Release R16.1.x.x
PRELIMINARY
6-23
Table 6-29: Troubleshooting Control Link Failure
 Step Action
1 Verify the span settings using the span view command on the active master GLI3 MMI
port. If these are set correctly, verify the edlc parameters using the
show command. Any
alarms conditions indicate that the span is not operating correctly.
- Try looping back the span line from the DSX panel back to the mobility manager
(MM) and verify that the looped signal is good.
- Listen for control tone on appropriate timeslot from base site and MM.
6