User Manual

LMF Operation68P09255A57-2

Aug 2002

SC4812ET Optimization/ATP Manual Software Release R16.1.x.x

PRELIMINARY

3-13

LMF Operation

Preparing the LMF

Before optimization can be performed, the LMF application software

must be installed and configured on a computer platform meeting

Motorola-specified requirements (see Recommended Test Equipment

and Software in Chapter 1).

NOTE

For the LMF graphics to display properly, the computer platform

must be configured to display more than 256 colors. See the

operating system software instructions for verifying and

configuring the display settings.

Software and files for installing and updating the LMF are provided on

CD ROM disks. The following items must be available:

 LMF Program on CD ROM

 CDF for each supported BTS (on diskette or available from the

CBSC)

 CBSC File for each supported BTS (on diskette or available from the

CBSC)

The following section provides information and instructions for

installing and updating the LMF software and files.

LMF Operating System Installation

Follow the procedure in Table 3-3 to install the LMF operating system.

Table 3-3: LMF Operating System Installation

Step Action

1 Insert the LMF Program CD ROM into the LMF CD ROM drive.

- If the Setup screen is displayed, go to step 5.

- If the Setup screen is not displayed, proceed to step 2.

2 Click on the Start button.

3 Select Run.

4 In the Open box, enter d:\autorun and click on the OK button.

NOTE

If applicable, replace the letter d with the correct CD ROM drive letter.

5 Follow the instructions displayed on the Setup screen.

. . . continued on next page