User Manual

RFDS Setup and Calibration – continued

SC4812ET BTS Optimization/ATP — CDMA LMF

Jan 2002

3-100

Table 3-46: RFDS Parameter Settings

Step Action

5g – Click OK to close the status report window.

5h – Click on the MGLI.

5i – Click on Device in the BTS menu bar, and select Enable from the pull–down menu.

–– A status report window is displayed showing status of the operation.

– When the operation is complete, click OK to close the status report window.

! CAUTION

When the MGLI changes to INS_ACT, data will automatically be downloaded to the RFDS. During

this process, the RFDS LED will slowly begin flashing red and green for approximately 2–3 minutes.

DO NOT attempt to perform any functions with the RFDS until the LED remains steady green.

5k – Re–seat the redundant GLI card into the backplane connectors and lock it in place with the ejector

tabs.

5l – Once the redundant GLI initializes, download data to it by selecting the card and, in the BTS

menu bar, clicking Device and selecting Download > Data from the pull–down menus.

6 Any MCCs which were INS_ACT when the MGLI was disabled must be disabled, re–enabled, and

downloaded with code as follows:

6a – Select the devices to be reset by clicking on them or using Select from the BTS menu bar and

clicking on MCCs in the pull–down menu.

6b – In the BTS menu bar, click on Device and select Disable from the pull–down menu.

–– A status window report window is displayed showing status of the operation.

6c – Click OK to close the status report window.

6d – Download data to the MCCs by following the procedure in Table 3-21.

6e – When data download is complete, enable the MCCs by following the procedure in Table 3-24.

7 Click on the RFDS tab.

8 Status the RFDS TSU by performing the following:

8a – Click on the SUA to select it.

8b – Click on TSU in the BTS menu bar, and select Status TSU from the pull–down menu.

–– A status report is displayed showing the software version number for the TSIC and SUA.

. . . continued on next page