User Manual
Bay Level Offset Calibration – continued
Jan 2002
3-95
SC4812ET BTS Optimization/ATP — CDMA LMF
All Cal/Audit Test
The Tests menu item, All Cal/Audit, performs the TX BLO Calibration
and Audit test for a XCVR(s). All measurements are made through the
appropriate TX output connector using the calibrated TX cable setup.
If the TX calibration portion of the test passed, the BLO
data will automatically be downloaded to the BBX(s)
before the audit portion of the test is run.
NOTE
Prerequisites
Before running this test, the following should be done:
CSM–1, GLI2s, BBXs have correct code and data load.
Primary CSM and MGLI2 are INS.
All BBXs are OOS_RAM.
Test equipment and test cables are calibrated and connected for TX
BLO calibration.
LMF is logged into the BTS.
Follow the procedures in Table 3-44 to perform the All Cal/Audit test.
Before installing any test equipment directly to any TX
OUT connector, first verify there are no CDMA BBX
channels keyed. Failure to do so can result in serious
personal injury and/or equipment damage.
WARNING
3