User Manual

Test Set Calibration – continued
Jan 2002
3-75
SC4812ET BTS Optimization/ATP — CDMA LMF
Table 3-30: Selecting Test Equipment Manually in a Serial Connection Tab
Step Action
6 Type the GPIB address in the corresponding GPIB address box (refer to the Setting GPIB Addresses
section of Appendix F for directions on verifying and/or changing test equipment GPIB addresses).
Motorola–recommended addresses are:
1 = signal generator
13 = power meter
18 = communications system analyzer
* IMPORTANT
When test equipment items are manually selected by the operator, the LMF defaults to using a power
meter for RF power measurements. The LMF will use a communications system analyzer for RF
power measurements only if a power meter is not selected (power meter checkbox not checked).
7 Click on Apply. (The button will darken until the selection has been committed.)
8 Click on Dismiss to close the test equipment window.
3