User's Manual
Index
68P09255A69-3
PRELIMINARY
Aug 2002
1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x
Index-9
LMF login failure, 6-2
power meter communication, 6-5
signal generator communication, 6-6
TSU NAM, programming
description, 3-96
parameter ranges, 3-97
parameters, 3-96
procedure, 3-102
TX
acceptance tests
code domain power/noise floor, 4-22
equipment setup, 4-6
pilot time offset, 4-20
spectral purity mask, 4-15
spectrum analyzer display, 4-17
waveform quality (rho), 4-18
all inclusive TX ATP test, 4-8
antenna VSWR, test data sheets, A-9, A-11
BLO test data sheets, A-8
level accuracy fault isolation, 6-13
output acceptance tests
code domain power noise, 4-13
pilot time offset, 4-13
waveform quality, 4-13
TX and RX Frequency vs Channel , D-2
TX and RX Signal Routing, SCCP Backplane
Troubleshooting, 6-24
TX Audit Test, 3-90
TX Bay Level Offset and TX ATP test equipment
setup calibration, signal generator and spectrum
analyzer, 3-73
TX calibration, 3-86
All Cal/Audit, 3-86
set-up, 3-58
Advantest R3267, 3-60, H-18
Advantest R3465, 3-59
Agilent 8935, 3-58
Agilent E4406A, 3-60, H-18
CyberTest, 3-58
HP 8921A, 3-59
TX calibration procedure, 3-88
TX combiners. See 2:1 combiners
tx fine adjust, E-1
TX path. See transmit path
TX path calibration, 3-86
TX/RX OUT Connections, 4-3
U
Updating CDMA LMF Files, 5-1
UTP, LMF to BTS connection, 3-22
V
verification during calibration, 3-79
Verify
test equipment used, test data sheets, A-1
TX output, 4-6
Verify GLI ROM code load, 3-34
version Folder, 3-12
W
Waveform quality (Rho), acceptance test procedure,
4-18
X
XCVR Backplane Troubleshooting, 6-19
Xircom Model PE3-10B2
LMF to BTS connection, 3-22
remove from BTS, 5-4