User's Manual

Index
68P09255A69-3
1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x
PRELIMINARY
Aug 2002
Index-8
RX path. See receive path
S
SC 4812 BTS Optimization/ATP Test Matrix, B-2
SCCP Backplane Troubleshooting, Procedure, 6-20
SCLPA, convergence test data sheets, A-7
Selecting Test Equipment, 3-68
Set Antenna Map Data, 3-98
Set RFDS Configuration Data, 3-99
Setting Cable Loss Values, 3-76
Setting Control Port, 3-15
Setting TX Coupler Loss Value, 3-77
shut-down, BTS power. See power, removal
SIF, output considerations vs BBX gain set point, C-1
signal generator, 1X FER acceptance test, 4-6
Site, equipage verification, 3-3
Site checklist, verification data sheets, A-2
Site documents, 1-12
site equipage, CDF file, 3-2
Site expansion, 1-4
Span line
T1/E1 verification equipment, 1-11
troubleshooting, 6-34
Span line configuration, troubleshooting, 6-36
Span Line connector , 6-19
SPANS LED, 6-30
Spectral purity, TX mask - primary and redundant
BBX, 4-13
Spectral purity transmit mask, acceptance test, 4-16
Spectrum analyzer, optional test equipment, 1-10
STATUS LED, GLI, 6-30
Supported Test Sets, 3-51
SYNC Monitor Connector, CSM, 6-29
System Connectivity Test, F-17
T
T1, isolate BTS from the T1 spans, 3-14
Tektronics model 2445 test equipment, 1-11
Test data sheets
Alarm verification, A-11
general optimization checklist, A-4
GPS receiver operation, A-5
initial power tests, A-3
LFR receiver operation, A-6
pre-power tests, A-3
preliminary operations, A-2
RX antenna VSWR, A-11
SCLPA convergence, A-7
site checklist, A-2
TX antenna VSWR, A-9
TX BLO, A-8
verification of test equipment used, A-1
Test equipment
See also Optional test equipment; Required test
equipment
set up, TX output verification/control, 4-6
system analyzer, 1-8
TX acceptance tests, 4-6
verification data sheets, A-1
Test equipment connections , preliminary Agilent
E4406A/E4432B set-up, F-22
Test Equipment Setup Calibration for RX Bay Level
Offset, signal generator and spectrum analyzer,
3-74
Test Equipment Setup Calibration for TX Bay Level
Offset, F-32
Test Equipment Setup Chart, 3-52
Test equipment setup RF path calibration, 3-82
Timing reference cables, required test equipment
Model SGLN1145A/4132A CSMs, 1-9
Model SGLN4132B CSMs, 1-9
transmit path
calibration, 3-78
component verification, 3-79
definition, 3-78
Transmit TX path audit, 3-90
Transmit TX path calibration, 3-83
Troubleshooting
DC Power Problems, 6-23
RF path fault isolation, 6-11
Set span configuration, 6-36
span problems, 6-34
TX and RX Signal Routing, 6-24
TX level accuracy fault isolation, 6-13
troubleshooting
communications system analyzer communication,
6-6
Ethernet LAN, 6-2
GLI IP address, 6-3