User's Manual

Index
68P09255A69-3
PRELIMINARY
Aug 2002
1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x
Index-3
Broad Band Receiver. See BBX
BTS
download, 3-33
Ethernet LAN interconnect diagram, 3-30
LMF connection, 3-15, 3-22
log out of session, 5-4
RX sensitivity/frame error rate, 4-14
system software download, 3-3
BTS Frame Erasure Rate. See FER
BTS Log In Procedure, GUI, 3-24
BTS login
CLI environment, 3-26
General, 3-24
GUI environment, 3-24
BTS Logout
CLI environment, 3-28
GUI environment, 3-27
Create CAL File, 3-92
bts-nnn.cal File, 3-11
C
cable calibration, automatic, test set-up, 3-55, 3-56
Advantest R3267/R3562, 3-56
Advantest R3465, 3-55
Agilent 8935, 3-55
Agilent E4406A/E4432B, 3-56, 3-57
CyberTest, 3-55
HP 8921A, 3-55
CAL file. See calibration data file
Calibrating Cables, 3-71
Calibrating Test Cable Setup, PCS Interface
HP83236B, F-28
Calibrating Test Equipment, 3-71
Calibration, In-Service, H-20
calibration
calibration data file, 3-79
Gigatronics 8542B, F-27
Calibration Audit failure, 6-10
calibration data file, description of, 3-79
Cannot communicate to Communications Analyzer,
6-6
Cannot communicate to Power Meter, 6-5
Cannot Download DATA to any device card, 6-7
Cannot ENABLE device, 6-8
Cannot Log into cell-site, 6-2
Cannot perform carrier measurement, 6-15
Cannot perform Code Domain Noise Power
measurement, 6-15
Cannot perform Rho or pilot time offset
measurement, 6-14
Cannot perform Txmask measurement, 6-14
cbsc folder, 3-11
CDF
site configuration, 3-2
site equipage verification, 3-3
site type and equipage data information, 2-1
CDMA
allocation diagram for the North American, cellular
telephone frequency spectrum, D-4
optimization/ATP test matrix, B-1
subscriber mobile radiotelephone, optional test
equipment, 1-11
cdma Folder, 3-10
Cell Site
equipage verification, 2-1
types configuration, 3-2
Cell Site Data File. See CDF
Channel Service Unit, 3-15
CIO Connectors, 6-20
Clock Sync Module. See CSM
Code domain power/noise floor
acceptance test, 4-23
analyzer display, 4-24
code Folder, 3-12
Communication test set, rear panel, F-14, F-16
Communications test set. See Test equipment
communications test set, TX acceptance tests, 4-6
Connect BTS E1/T1 spans, 5-5
Connect BTS T1/E1 spans, 5-5
Connecting test equipment to the BTS, 3-50
Connector Functionality
Backplane, Troubleshooting, 6-19
Troubleshooting, Backplane, 6-19
Control, TX output verification, 4-6
Copy CBSC CDF Files to the LMF, 3-5
Copying CAL files from CDMA LMF to the CBSC,
5-1
Copying CAL files to the CBSC, 5-1
CSM
clock source, select, 3-36