User's Manual

Setting GPIB Addresses68P09255A69-3

Aug 2002

1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x

PRELIMINARY

F-11

HP 437 Power Meter GPIB Address

Figure F-8: HP 437 Power Meter

ENTER

PRESET

SHIFT (BLUE) PUSHBUTTON -

ACCESSES FUNCTION AND

DATA ENTRY KEYS IDENTIFIED

WITH LIGHT BLUE TEXT ON

THE FRONT PANEL ABOVE

THE BUTTONS

FW00308REF

Refer to Figure F-8 and follow the steps in Table F-8 to verify and, if

necessary, change the HP 437 GPIB address.

NOTE

This procedure assumes that the test equipment is set up and

ready for testing.

Table F-8: Verify and/or Change HP 437 Power Meter GPIB Address

Step Action

1 Press Shift and PRESET.

2 Use the  arrow key to navigate to HP-IB ADRS and press ENTER.

The HP-IB address is displayed.

NOTE

HP-IB is the same as GPIB.

3 If the current GPIB address is not set to 13, perform the following to change it:

- Use the   arrow keys to change the HP-IB ADRS to 13.

- Press ENTER to set the address.

4 Press Shift and ENTER to return to a standard configuration.