User's Manual

Setting GPIB Addresses68P09255A69-3

Aug 2002

1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x

PRELIMINARY

F-9

Table F-5: Verify and/or Change HP 8921A and HP 83236A GPIB Addresses

Step Action

2e - Press Shift and Preset to return to normal operation.

3 To set the HP 83236A (or B) PCS Interface GPIB address=19, set the DIP switches as follows:

- A1=1, A2=1, A3=0, A4=0, A5=1, HP-IB/Ser = 1

Advantest R3465 GPIB Address

Figure F-7: R3465 Communications Test Set

BNC

“T”

REF UNLOCK

EVEN

SEC/SYNC IN

CDMA

TIME BASE IN

POWER

OFF

LCL Shift Preset

GPIB and others

Vernier

Knob

REF FW00337

Refer to Figure F-7 and follow the procedure in Table F-6 to verify and,

if necessary, change the GPIB address for the Advantest R3465.

NOTE

This procedure assumes that the test equipment is set up and

ready for testing.

Table F-6: Verify and/or Change Advantest R3465 GPIB Address

Step Action

1 To verify that the GPIB address is set correctly, perform the following:

1a - Press SHIFT then PRESET.

1b - Press LCL.

1c - Press the GPIB and Others CRT menu key to view the current address.

2 If the current GPIB address is not set to 18, perform the following to change it:

2a - Turn the vernier knob as required to select 18.

2b - Press the vernier knob to set the address.

3 To return to normal operation, press Shift and Preset.