User's Manual

Setting GPIB Addresses

68P09255A69-3

Aug 2002

1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x

PRELIMINARY

F-8

Setting HP 8921A and HP 83236A/B GPIB Address

Figure F-6: HP 8921A and HP 83236A/B

Preset

Cursor ControlShift

Local

Refer to Figure F-6 and follow the procedure in Table F-5 to verify and,

if necessary, change the HP 8921A HP 83236A GPIB addresses.

NOTE

This procedure assumes that the test equipment is set up and

ready for testing.

Table F-5: Verify and/or Change HP 8921A and HP 83236A GPIB Addresses

Step Action

To verify that the GPIB addresses are set correctly, press Shift and LOCAL on the HP 8921A.

- The current HP-IB address is displayed at the top of the screen.

NOTE

HP-IB is the same as GPIB.

2 If the current HP-IB address is not set to 18, perform the following to change it:

2a - Turn the Cursor Control knob to move the cursor to More and press the knob to select the field.

2b - Turn the Cursor Control knob to move the cursor to I/O Config and press the knob to select the

field.

2c - Turn the Cursor Control knob to move the cursor to Adrs and press the knob to select the field.

2d - Turn the Cursor Control knob to change the HP-IB address to 18 and press the knob to set the

address.