User's Manual

Setting GPIB Addresses

68P09255A69-3

Aug 2002

1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x

PRELIMINARY

F-6

Table F-3: Verify and Change Advantest R3267 GPIB Address

Step Action

1 If the REMOTE LED is lighted, press the LCL key.

- The LED extinguishes.

2 Press the CONFIG key.

- The CONFIG softkey labels will appear in the softkey label display area of the instrument

display.

- The current GPIB address will be displayed below the GPIB Address softkey label.

3 If the current GPIB address is not set to 18, perform the following to change it:

3a - Press the GPIB Address softkey.

-- A GPIB Address entry window will open in the instrument display showing the current

GPIB address.

- Enter 18 on the keypad in the ENTRY section of the instrument front panel.

-- Characters typed on the keypad will replace the address displayed in the GPIB Address

entry window.

NOTE

To correct an entry, press the BS (backspace) key at the lower right of the keypad to delete one

character at a time.

3c - Press the ENTR key to the lower right of the keypad to set the new GPIB address.

-- The GPIB Address entry window closes.

-- The new address is displayed in the bottom portion of the GPIB Address softkey label.

Advantest R3562 Signal Generator GPIB Address

Set the GP-IB ADDRESS switch on the rear of the Advantest R3562

signal generator to address 1 as shown in Figure F-4.

Figure F-4: Advantest R3562 GPIB Address Switch Setting

12345678

54321

GP-IP ADDRESS

GPIB Address set to “1”