User's Manual

Setting GPIB Addresses68P09255A69-3
Aug 2002
1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x
PRELIMINARY
F-5
Table F-2: Verify and Change Agilent E4432B GPIB Address
Step Action
3 If the current GPIB address is not set to 1, perform the following to change it:
3a - Press the GPIB Address softkey button.
-- The GPIB Address label and current GPIB address will change to boldface.
-- In the on-screen Active Entry Area, Address: will be displayed followed by the current
GPIB address.
3b
- On the front panel Numeric keypad, enter the signal generator GPIB address of 1.
-- The GPIB Address label will change to Enter.
-- Characters typed on the keypad will replace the current GPIB address in the Active Entry
display.
NOTE
To correct an entry, press the backspace key at the lower right of the keypad to delete one character at
a time.
3c - Press the Enter softkey button to set the new GPIB address.
-- The new GPIB address will be displayed under the GPIB Address softkey label.
Advantest R3267 Spectrum Analyzer GPIB Address
Figure F-3: Setting Advantest R3267 GPIB Address
o
n
REMOTE
LED
LCL Key
CONFIG
Key
Softkey Lable
Display Area
Softkey
Buttons
Keypad BS
Key
ENTR
Key
Refer to Figure F-3 and perform the procedure in Table F-3 to verify
and, if necessary, change the Advantest R3267 spectrum analyzer GPIB
address.
F