User's Manual

Setting GPIB Addresses
68P09255A69-3
Aug 2002
1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x
PRELIMINARY
F-4
Table F-1: Verify and Change Agilent E4406A GPIB Address
Step Action
3b
- On the front panel Data Entry keypad, enter the communications system analyzer GPIB address of
18.
-- The GPIB Address label will change to Enter.
-- Characters typed on the keypad will replace the current GPIB address in the Active Function
Area.
NOTE
To correct an entry, press the Bk Sp key at the upper right of the keypad to delete one character at a
time.
3c - Press the Enter softkey button or the keypad Enter key to set the new GPIB address.
-- The Config I/O softkey labels will reappear.
-- The new GPIB address will be displayed under the GPIB Address softkey label.
Agilent E4432B Signal Generator GPIB Address
Figure F-2: Setting Agilent E4432B GPIB Address
Numeric
Keypad
Softkey
Buttons
Softkey Label
Display Area
Active Entry
Area
Backspace
Key
Utility
Key
Refer to Figure F-2 and follow the procedure in Table F-2 to verify and,
if necessary, change the Agilent E4432B GPIB address.
Table F-2: Verify and Change Agilent E4432B GPIB Address
Step Action
1 In the MENUS section of the instrument front panel, press the Utility key.
- The softkey labels displayed on the right side of the instrument screen will change.
2 Press the GPIB/RS232 softkey button to the right of the instrument screen.
- The softkey labels will change.
- The current instrument GPIB address will be displayed below the GPIB Address softkey label.
. . . continued on next page
F