User's Manual

Troubleshooting: Installation – continued
PRELIMINARY
1X SCt4812ET Lite BTS Optimization/ATP
08/01/2001
6-4
Table 6-3: GLI IP Address Setting
n Step Action
1 If it has not previously been done, establish an MMI communication session with
the GLI card as described in Table 3-11.
2 Enter the following command to display the IP address and subnet mask settings
for the card:
config lg0 current
A response similar to the following will be displayed:
GLI2>config lg0 current
lg0: IP address is set to
DEFAULT (configured based on card location)
lg0: netmask is set to
DEFAULT (255.255.255.128)
3 If the IP address setting response shows an IP address rather than “Default
(configured based on card location),” enter the following:
config lg0 ip default
A response similar to the following will be displayed:
GLI2>config lg0 ip default
_param_config_lg0_ip(): param_delete(): 0x00050001
lg0: ip address set to DEFAULT
4 If the GLI subnet mask setting does not display as “DEFAULT
(255.255.255.128),” set it to default by entering the following command:
config lg0 netmask default
A response similar to the following will be displayed:
GLI2>config lg0 netmask default
_param_config_lg0_netmask(): param_delete(): 0x00050001
lg0: netmask set to DEFAULT
. . . continued on next page
6