User's Manual

Basic Troubleshooting – Span Control Link – continued

PRELIMINARY

1X SCt4812ET Lite BTS Optimization/ATP

08/01/2001

6-38

Table 6-30: Set BTS Span Parameter Configuration

n ActionStep

6 If the current MGLI/GLI span rate must be changed, enter the following MMI command:

config ni linkspeed <cr>

The terminal will display a response similar to the following:

Next available options:

LIST – linkspeed : Span Linkspeed

56K : 56K (default for T1_1 and T1_3 systems)

64K : 64K (default for all other span configurations)

NOTE

With this command, all active (in–use) spans will be set to the same linkspeed.

To set or change the span linkspeed, enter the required option from the list at the entry prompt (>),

as shown in the following example:

> 64K <cr>

NOTE

The entry is case–sensitive and must be typed exactly as it appears in the list. If the entry is typed

incorrectly, a response similar to the following will be displayed:

CP: Invalid command

GLI2>

8 An acknowledgement similar to the following will be displayed:

The value has been programmed. It will take effect after the next reset.

GLI2>

9 If the span equalization must be changed, enter the following MMI command:

config ni equal <cr>

The terminal will display a response similar to the following:

COMMAND SYNTAX: config ni equal span equal

Next available options:

LIST – span : Span

a : Span A

b : Span B

c : Span C

d : Span D

e : Span E

f : Span F

. . . continued on next page