User's Manual

Troubleshooting: Download
08/01/2001
6-7
1X SCt4812ET Lite BTS Optimization/ATP
PRELIMINARY
Table 6-6: Troubleshooting Code Download Failure
n Step Action
1 Verify T1 or E1 span is disconnected from the BTS at CSU.
2 Verify LMF can communicate with the BTS device using the Status function.
3 Communication to MGLI2 must first be established before trying to talk to any
other BTS device. MGLI2 must be INS_ACT state (green).
4 Verify the card is physically present in the cage and powered-up.
5 If card LED is solid RED, it implies hardware failure. Reset card by re-seating it.
If this persists, replace card from another slot & retry.
NOTE
The card can only be replaced by a card of the same type.
6 Re-seat card and try again.
7 If BBX2 reports a failure message and is OOS_RAM, the code load was OK.
Status it to verify the load.
8 If the download portion completes and the reset portion fails, reset the device by
clicking on the device and selecting DEVICE > RESET.
Cannot Download DATA to Any
Device (Card)
Table 6-7: Troubleshooting Data Download Failure
n Step Action
1 Re-seat card and repeat code and data load procedure.
2 Verify the ROM and RAM code loads are of the same release by statusing the
card. Refer to Chapter 3, “Download the BTS” for more information.
6