User's Manual

Preparing the LMF – continued
08/01/2001
3-5
1X SCt4812ET Lite BTS Optimization/ATP
PRELIMINARY
Table 3-1: CD ROM Installation
n ActionStep
3 Select Run.
4 Enter d:\autorun in the Open box and click OK.
NOTE
(If applicable, replace the letter d with the correct CD ROM drive letter.)
5 Follow the directions displayed in the Setup screen.
Copy CBSC CDF Files to the
LMF Computer
Before logging on to a BTS with the CDMA LMF computer to execute
optimization/ATP procedures, the correct bts-#.cdf and
cbsc-#.cdf files must be obtained from the CBSC and put in a
bts-# folder in the CDMA LMF computer. This requires creating
versions of the CBSC CDF files on a DOS–formatted floppy diskette
and using the diskette to install the CDF files on the CDMA LMF
computer.
When copying CDF files, comply with the following to
prevent BTS login problems with the Windows LMF:
S The numbers used in the bts-#.cdf and
cbsc-#.cdf filenames must correspond to the
locally–assigned numbers for each BTS and its
controlling CBSC.
S The generic cbsc–1.cdf file supplied with the Windows
LMF will work with locally numbered BTS CDF files.
Using this file will not provide a valid optimization
unless the generic file is edited to replace default
parameters (e.g., channel numbers) with the operational
parameters used locally.
IMPORTANT
*
The procedure in Table 3-2 lists the steps required to transfer the CDF
files from the CBSC to the CDMA LMF computer. For any further
information, refer to the CDMA LMF Operator’s Guide (Motorola part
no. 68P64114A21) or the CDMA LMF Help screen.
Table 3-2: Copying CBSC CDF Files to the LMF Computer
Step Action
1 Login to the CBSC workstation.
2 Insert a DOS–formatted floppy diskette in the workstation drive.
3 Type eject –q and press the Enter key.
. . . continued on next page
3