User's Manual

Using CDMA LMF – continued
PRELIMINARY
1X SCt4812ET Lite BTS Optimization/ATP
08/01/2001
3-22
separate FRAME tab for each frame(for example, FRAME–438–1, and
FRAME–438–101 for BTS–438 that has both frames). If an RFDS is
included in the CDF file, an RFDS tab (e.g., RFDS–438–1) will be
displayed.
Actions, such as ATP tests, can be initiated for selected devices in one or
more frames of a logical BTS. Refer to the CDMA LMF Select devices
help screen for information on how to select devices.
Logging Into a BTS
Be sure that the correct bts–#.cdf and cbsc–#.cdf file is
used for the BTS. These should be the CDF files that are
provided for the BTS by the CBSC. Failure to use the
correct CDF files can result in invalid optimization.
Failure to use the correct CDF files to log into a live
(traffic–carrying) site can shut down the site.
CAUTION
Logging into a BTS establishes a communications link between the BTS
and the CDMA LMF. You may be logged into one or more BTSs at a
time, but only one CDMA LMF may be logged into each BTS.
Before attempting to start the CDMA LMF computer and the CDMA
LMF software, confirm the CDMA LMF computer is properly connected
to the BTS (see Table 3-6). Follow the procedures in Table 3-7 to log
into a BTS.
Prerequisites
Before attempting to log into a BTS, ensure the following have been
completed:
S The CDMA LMF is correctly installed and prepared.
S A bts-nnn folder with the correct CDF and CBSC files exists.
S The CDMA LMF computer was connected to the BTS before starting
the Windows operating system and the CDMA LMF software. If
necessary, restart the computer after connecting it to the BTS in
accordance with Table 3-6 and Figure 3-10.
3