User's Manual

RFDS Set-up and Calibration68P09255A69-3
Aug 2002
1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x
PRELIMINARY
3-97
Set Antenna Map Data
The antenna map data must be entered manually if an RFDS is installed.
Antenna map data does not need to be entered if an RFDS is not
installed. The antenna map data is only used for RFDS tests and is
required if an RFDS is installed.
Prerequisite
 LMF is logged into the BTS
Follow the procedure in Table 3-48 to set antenna map data for the
RFDS.
Table 3-48: Set Antenna Map Data
Step Action
1 Click on Util in the BTS menu bar, and select Edit > Antenna Map... from the pull-down menus.
-A tabbed data entry pop-up window will appear.
2 In the data entry pop-up window, click on the TX Antenna Map or RX Antenna Map tab to select
the antenna map to be edited.
3 Locate the carrier and sector number for which data is to be entered or edited, and click in the column
where entry or editing is needed.
4
Enter/edit Antenna # and Antenna Label column data as needed for each carrier.
NOTE
Refer to the CDMA Help > Utility Menu > Edit-Antenna Map... section of LMF Help function
on-line documentation for antenna map examples.
5 For each tab with changes, click on the Save button to save displayed values.
6
Click on the Dismiss button to close the window.
NOTE
 Values entered or changed after the Save button was used will be lost when the window is
dismissed.
 Entered values will be used by the LMF as soon as they are saved. It is not necessary to log out and
log back into the LMF for changes to take effect.
3