User's Manual

RFDS Set-up and Calibration68P09255A69-3

Aug 2002

1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x

PRELIMINARY

3-95

Explanation of Parameters Used When Programming the TSU NAM

Table 3-46 defines the parameters used when editing the tsu.nam file.

Table 3-46: Definition of Parameters

Access Overload Code

Slot Index

System ID

Network ID

These parameters are obtained from the switch.

Primary Channel A

Primary Channel B

Secondary Channel A

Secondary Channel B

These parameters are the channels which are to be used in operation

of the system.

Lock Code

Security Code

Service Level

Station Class Mark

Do NOT change.

IMSI MCC

IMSI 11 12

These fields are obtained at the OMC using the following command:

OMC000>disp bts-# imsi

If the fields are blank, replace the IMSI fields in the NAM file to 0,

otherwise use the values displayed by the OMC.

MIN Phone Number These fields are the phone number assigned to the mobile. The ESN

and MIN must be entered into the switch as well.

NOTE

This field is different from the TODN field in the bts-#.cdf file. The

MIN is the phone number of the RFDS subscriber, and the TODN is

the number the subscriber calls.