User's Manual
Bay Level Offset Calibration68P09255A69-3
Aug 2002
1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x
PRELIMINARY
3-83
Test Pattern Drop-down Pick List
Test Pattern Default and Descriptions - Pilot is shown as the default
setting in this picklist box. The full range of available selections and
their descriptions are as follows:
Standard - performs calibration or audit using pilot, paging, synch,
and six traffic channels with IS-97-specified gain. This pattern setting
should be used for all non-in-service calibrations and audits. Using
this pattern setting requires the selection of both a BBX and at least
one MCC.
Pilot (default) - performs calibration using only the pilot channel.
This pattern setting should be used for in-service calibrations, and
requires selection of only a BBX.
CDFPilot - This pattern setting is for advanced users. It performs
calibration or audit using the CDF value for pilot gain and IS-97 gain
values for all the other channels included in the Standard pattern
setting (paging, synch, and six traffic). Using this pattern setting
requires the selection of both a BBX and at least one MCC.
CDF - This pattern setting is for advanced users who need to use
CDF gain settings for all channels included in the Standard pattern
setting (pilot, paging, synch, and six traffic). Using this pattern setting
requires the selection of both a BBX and at least one MCC.
Test Pattern Channels and Gain Settings - The CDMA channels and
their respective digital gain settings used for each test pattern are listed
in Table 3-39.
Table 3-39: Test Patterns with Channels and Gain Settings Used
Test Pattern Channel(s) Gain Setting
Pilot Pilot channel
only
541
Standard
Pilot 117
Synch channel
(SCH)
57
Paging (PCH) 114
Traffic (TCH) 80 for each of 6 Walsh codes
used (6*80)
CDF Pilot
Pilot Uses CDF-specified pilot gain
SCH 57
PCH 114
TCH 6*80
CDF
Pilot
All channels use CDF-specified
SCH
gains
PCH
TCH (6)
3