User's Manual

Test Equipment Set-up68P09255A69-3

Aug 2002

1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x

PRELIMINARY

3-49

Supported Test Equipment

CAUTION

To prevent damage to the test equipment, all transmit (TX) test

connections must be through a 30 dB directional coupler plus a

20 dB in-line attenuator for both the 800 MHz and 1.9 GHz

BTSs.

IS-95A/B Operation

Optimization and ATP testing for IS-95A/B sites or carriers may be

performed using the following test equipment:

 CyberTest

 Advantest R3267 spectrum analyzer with R3562 signal generator

 Advantest R3465 spectrum analyzer with R3561L signal generator

and HP-437B or Gigatronics Power Meter

 Agilent E4406A transmitter test set with E4432B signal generator

 Agilent 8935 series E6380A communications test set (formerly HP

8935)

 Hewlett-Packard HP 8921 (with CDMA interface and, for 1.9 GHz,

PCS Interface) and HP-437B or Gigatronics Power Meter

 Spectrum Analyzer (HP8594E) - optional

 Rubidium Standard Timebase - optional

CDMA2000 1X Operation

Optimization and ATP testing for CDMA2000 1X sites or carriers may

be performed using the following test equipment:

 Advantest R3267 spectrum analyzer with R3562 signal generator

 Agilent E4406A transmitter test set with E4432B signal generator

 Agilent 8935 series E6380A communications test set (formerly HP

8935) with option 200 or R2K and with E4432B signal generator for

1X FER

Test Equipment Preparation

See Appendix F for specific steps to prepare each type of test set and

power meter to perform calibration and ATP .