User's Manual

CSM System Time - GPS & LFR/HSO Verification68P09255A69-3

Aug 2002

1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x

PRELIMINARY

3-43

Table 3-24: GPS Initialization/Verification

Step Action

HSO information (underlined text above, verified from left to right) is usually the #1 reference source.

If this is not the case, have the OMCR determine the correct BTS timing source has been identified in

the database by entering the

display bts csmgen command and correct as required using the edit

csm csmgen refsrc command.

NOTE

If any of the above areas fail, verify:

- If LED is RED, verify that HSO had been powered up for at least 5 minutes. After oscillator

temperature is stable, LED should go GREEN Wait for this to occur before continuing !

- If “timed out” is displayed in the Last Phase column, suspect the HSO output buffer or oscillator

is defective

- Verify the HSO is FULLY SEATED and LOCKED to prevent any possible card warpage

4 Verify the following GPS information (underlined text above):

- GPS information is usually the 0 reference source.

- At least one Primary source must indicate “Status = good” and “Valid = yes” to bring site up.

. . . continued on next page