User's Manual

Download the BTS68P09255A69-3

Aug 2002

1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x

PRELIMINARY

3-37

Enable MCCs

This procedure configures the MCC and sets the “tx fine adjust”

parameter. The “tx fine adjust” parameter is not a transmit gain setting,

but a timing adjustment that compensates for the processing delay in the

BTS (approximately 3 mS).

Follow the steps outlined in Table 3-22 to enable the MCCs installed in

the SCCP shelves.

NOTE

The MGLI and CSM must be downloaded and enabled, prior to

downloading and enabling an MCC.

Table 3-22: Enable MCCs

Step Action

1 If the GLI/MCC/BBX view is not displayed in the LMF window, click on the GLI/MCC/BBX area of the

SCCP shelf.

2 Click on the target MCC(s), or click on Select in the BTS menu bar, and select MCCs in the

pull-down menu list.

3 click on Device in the BTS menu bar, and select Enable in the pull-down menu list.

- A status report is displayed showing the results of the enable operation.

4 Click OK to close the status report window.