User's Manual

Using the LMF68P09255A69-3

Aug 2002

1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x

PRELIMINARY

3-23

Table 3-11: BTS GUI Login Procedure

 ActionStep

3 Double click on CDMA (in the Available Base Stations pick list).

4 Click on the desired BTS number.

5 Click on the Network Login tab (if not already in the forefront).

6 Enter correct IP address (normally 128.0.0.2) for a field BTS, if not correctly displayed in the IP

Address box.

7 Type in the correct IP Port number (normally 9216) if not correctly displayed in the IP Port box.

8 Click on Ping.

- If the connection is successful, the Ping Display window shows text similar to the following:

Reply from 128 128.0.0.2: bytes=32 time=3ms TTL=255

- If there is no response the following is displayed:

128.0.0.2:9216:Timed out

If the MGLI fails to respond, reset and perform the ping process again. If the MGLI still fails to

respond, typical problems are shorted BNC to inter-frame cabling, open cables, crossed A and B

link cables, missing 50-Ohm terminators, or the MGLI itself.

Select the Multi-channel Preselector type from the Multi-channel Preselector drop-down list

(default is MPC) to a device corresponding to your BTS configuration, if required.

NOTE

Use a Tower Top Amplifier is not applicable to the SC4812ET Lite.

Click on Login. (A BTS tab with the BTS and frame numbers is displayed.)

NOTE

 If an attempt is made to log into a BTS that is already logged on, all devices will be gray.

 There may be instances where the BTS initiates a log out due to a system error (i.e., a device

failure).

 If the MGLI is OOS-ROM (blue), it must be downloaded with RAM code before other devices

can be seen.

 If the MGLI is OOS-RAM (yellow), it must be enabled before other installed devices can be

seen.