User's Manual

Preparing the LMF68P09255A69-3

Aug 2002

1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x

PRELIMINARY

3-5

Preparing the LMF

Overview

Before optimization can be performed, the LMF application software

must be installed and configured on a computer platform meeting

Motorola-specified requirements (see Recommended Test Equipment

and Software in Chapter 1).

NOTE

For the LMF graphics to display properly, the computer platform

must be configured to display more than 256 colors. See the

operating system software instructions for verifying and

configuring the display settings.

Software and files for installing and updating the LMF are provided on

CD ROM disks. The following items must be available:

 LMF application program on CD ROM

 Configuration Data File (CDF) for each supported BTS (on floppy

disk or CD ROM)

 CBSC File for each supported BTS (on floppy disk or CD ROM)

The following section provides information and instructions for

installing and updating LMF software and files.

LMF Installation and Update Procedures

NOTE

First Time Installation Sequence:

1. Install Java Runtime Environment (JRE)

2. Install U/WIN K-shell emulator

3. Install LMF application programs

4. Install/create BTS folders

Follow the procedure in Table 3-1 to install the LMF application

program using the LMF CD ROM.

Table 3-1: CD ROM Installation

Step Action

1 Insert the LMF CD ROM disk into your disk drive and perform the following as required:

1a - If the Setup screen appears, follow the instructions displayed on the screen.

1b - If the Setup screen is not displayed, proceed to Step 2.

2 Click on the Start button

3 Select Run.

Enter d:\autorun in the Open box and click OK.

NOTE

(If applicable, replace the letter d with the correct CD ROM drive letter.)

5 Follow the directions displayed in the Setup screen.