User's Manual

Optimization Manual Scope and Layout

68P09255A69-3

Aug 2002

1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x

PRELIMINARY

1-2

Optimization Manual Scope and Layout

Manual Scope and Layout

This document provides information pertaining to the optimization and

audit tests of the Motorola SC4812ET Lite Radio Frequency (RF) Base

Transceiver Station (BTS) equipment frame and its associated internal

and external interfaces in stand-alone and companion frame

installations. The following subjects are addressed: preliminary

background information; optimization and alarm/redundancy tests;

Acceptance Test Procedures (ATP) to verify site operation and regulation

compliance; site turnover; troubleshooting.

Most applications use the same test procedure for all equipment

variations. However, decision break points are provided throughout the

procedure when equipment-specific tests are required. For example,

when tests using external test equipment are performed instead of those

using the RFDS, additional test procedures and illustrations are provided

to cover both applications.

This optimization procedure consists of a group of task-oriented tests.

Each major test category (Audit, Initial power-up, Calibration, etc.) is

described in chapters which are broken down into multi-page

information “maps.”

Each “map” contains the information necessary to perform the test or

operation. Included are all required input levels, output levels, Local

Maintenance Facility (LMF) application software commands, and test

point identification. Also described are important test process concepts

and equipment operation which should be understood by the operator.

Whenever possible, graphics, flowcharts, or written examples

complement the information or procedural steps.

Assumptions and Prerequisites

This document assumes that the BTS frames and cabling have been

installed per the Frame Mounting Guide Analog/CDMA/TDMA;

68P09226A18, which covers the physical “bolt down” of all SC series

equipment frames, and the SC4812ET Lite Installation; 68P09253A36,

which covers BTS-specific cabling configurations.