User's Manual

Preparing the LMF

68P09255A69-3

Aug 2002

1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x

PRELIMINARY

3-10

Table 3-4: Create HyperTerminal Connection

Step Action

NOTE

For LMF computer configurations where COM1 is used by another interface such as test equipment

and a physical port is available for COM2, select COM2 in the following step to prevent conflicts.

4 From the Connect using: pick list in the Connect To box displayed, select Direct to Com 1 or Direct

to Com 2 for the RS-232 connection port, and click OK.

5 In the Port Settings tab of the COM# Properties window displayed, configure the RS-232 port

settings as follows:

 Bits per second: 9600

 Data bits: 8

 Parity: None

 Stop bits: 1

 Flow control: None

6 Click OK.

7 Save the defined connection by selecting:

File > Save

8 Close the HyperTerminal window by selecting:

File > Exit

9 Click the Yes button to disconnect when prompted.

10 If the Hyperterminal folder window is still open, proceed to step 12.

11 Select Communications and double click the Hyperterminal folder.

12 Highlight the newly-created connection icon by clicking on it.

13 Right click and drag the highlighted connection icon to the Windows desktop and release the right

mouse button.

14 From the popup menu which appears, select Create Shortcut(s) Here.

15 If desired, reposition the shortcut icon for the new connection by dragging it to another location on the

Windows desktop.

16 Close the Hyperterminal folder window by selecting:

File > Close