User's Manual

Abbreviated (All-inclusive) Acceptance Tests68P09255A69-3

Aug 2002

1X SC4812ET Lite BTS Optimization/ATP Software Release 2.16.1.x

PRELIMINARY

4-13

Table 4-7: All RX ATP Test Procedure

Step Action

In the Rate Set box, select the appropriate data rate (1=9600, 2=14400, 3=9600 1X) from the

drop-down list.

NOTE

The Rate Set selection of 1 is only available if non-1X cards are selected for the test.

The Rate Set selection of 3 is only available if 1X cards are selected for the test.

9 Enter the channel elements to be tested for the RX ATP in the Channel Element(s) box. By default,

all channel elements are specified.

Use one of thefollowing methods to enter more than one channel element:

- Enter non-sequential channel elements separated by a comma and no spaces (for example;

0,5,15).

- Enter a range of sequential channel elements by typing the first and last channel elements

separated by two periods (for example; 0..15).

NOTE

The channel element numbers are 0.based; that is the first channel element is 0.

10 Click OK to display a status bar followed by a Directions pop-up window.

NOTE

When testing diversity RX paths on companion frames, be sure to follow the RX test cable connection

information in Table 4-1 or Table 4-2, as applicable, during this step.

Follow cable connection directions as they are displayed, and click the Continue button to begin

testing.

- When the ATP process is completed, results will be displayed in the status report window.

12 Click the Save Results or Dismiss button.

NOTE

If Dismiss is used, the test results will not be saved in the test report file.