User's Manual
Table Of Contents
- Table of Contents
- List of Figures
- List of Tables
- Foreword
- FCC Requirements
- General Safety
- Revision History
- Patent Notification
- Chapter 1 Introduction
- Chapter 2 Preliminary Operations
- Chapter 3 Optimization/Calibration
- Optimization/Calibration - Introduction
- Isolate Span Lines/Connect LMF
- Preparing the LMF
- Using CDMA LMF
- Download the BTS
- CSM System Time/GPS and LFR/HSO Verification
- Test Equipment Set-up
- Test Set Calibration
- Bay Level Offset Calibration
- RFDS Set-up and Calibration
- BTS Redundancy/Alarm Testing
- BTS Alarms Testing
- Preliminary Operations: Overview
- Pre-Power-up Tests
- Initial Power-up Tests
- Chapter 4 Automated Acceptance Test Procedure
- Automated Acceptance Test Procedures - All-inclusive TX & RX
- TX Output Acceptance Tests: Introduction
- TX Spectral Purity Transmit Mask Acceptance Test
- TX Waveform Quality (rho) Acceptance Test
- TX Pilot Time Offset Acceptance Test
- TX Code Domain Power/Noise Floor Acceptance Test
- RX Frame Error Rate (FER) Acceptance Test
- Generate an ATP Report
- Chapter 5 Prepare to Leave the Site
- Chapter 6 Basic Troubleshooting
- Basic Troubleshooting Overview
- Troubleshooting: Installation
- Troubleshooting: Download
- Troubleshooting: Calibration
- Troubleshooting: Transmit ATP
- Troubleshooting: Receive ATP
- Troubleshooting: CSM Check-list
- C-CCP Backplane Troubleshooting
- Module Front Panel LED Indicators and Connectors
- Basic Troubleshooting - Span Control Link
- Appendix A Data Sheets
- Appendix B PN Offset/I & Q Offset Register Programming Information
- Appendix C FRU Optimization/ATP Test Matrix
- Appendix D BBX Gain Set Point vs. BTS Output
- Appendix E CDMA Operating Frequency
- Appendix F PCS Interface Setup for Manual Testing
- Appendix G VSWR
- Appendix H Download ROM Code
- Appendix I In-Service Calibration
- Appendix J GPIB Addresses
- Introduction
- HP437 Power Meter GPIB Address
- Gigatronics 8541C Power Meter GPIB Address
- Motorola CyberTest GPIB Address
- HP8935 Test Set GPIB Address
- Setting HP8921A and HP83236A/B GPIB Address
- Advantest R3465 GPIB Address
- RS232 GPIB Interface Box
- Advantest R3267 Spectrum Analyzer GPIB Address
- Agilent E4406A Transmitter Tester GPIB Address
- Index
BTS Equipment Identification68P09255A61-4
Aug 2002
1X SC 4812T BTS Optimization/ATP Software Release 2.16.1.x
FIELD TRIAL
1-17
Logical BTS Numbering
The first frame of a logical BTS has a -1 suffix (e.g., BTS-812-1 ).
Other frames of the logical BTS are numbered with suffixes, -101 , -201 ,
and -301 (e. g. BTS-812-201 ). When you log into a BTS, a FRAME
tab is displayed for each frame. If there is only one frame for the BTS,
there is only one tab (e.g., FRAME-282-1 ) for BTS-282. If a logical
BTS has more than one frame, there is a separate FRAME tab for each
frame (e.g. FRAME-438-1 , FRAME-438-101 , and FRAME-438-201
for a BTS-438 that has three frames). If an RFDS is included in the
CDF file, an RFDS tab (e.g., RFDS-438-1) is displayed.
Actions (e.g., ATP tests) can be initiated for selected devices in one or
more frames of a logical BTS. Refer to the Select devices help screen for
information on how to select devices.
C-CCP Shelf Card/Module Device ID Numbers
All cards/modules/boards in the frames at a single site, assigned to a
single BTS number, are also identified with unique Device ID numbers
dependent upon the Frame ID number in which they are located. Refer to
Table 1-2 and Table 1-3 for specific C-CCP Shelf Device ID numbers.
Table 1-2: C-CCP Shelf/Cage Card/Module Device ID Numbers (Top Shelf)
Frame Card/Module ID Number (Left to Right)
#
Power
(PS-1)
Power
(PS-2)
Power
(PS-3)
AMR
-1
GLI2
-1
MCC BBX BBX-
R
MPC/
EMPC
-1
1 - - - 1 1 1 2 3 4 5 6 1 2 3 4 5 6 R1 -
101 - - - 101 101 101 102 103 104 105 106 101 102 103 104 105 106 R101 -
201 - - - 201 201 201 202 203 204 205 206 201 202 203 204 205 206 R201 -
301 - - - 301 301 301 302 303 304 305 306 301 302 303 304 305 306 R301 -
Table 1-3: C-CCP Shelf/Cage Card/Module Device ID Numbers (Bottom Shelf)
Frame Card/Module ID Number (Left to Right)
#
HSO/
LFR
CSM
-1
CSM
-2
CCD
A
CCD
B
AMR
-2
GLI2-
2
MCC BBX SW MPC/
EMPC
-2
1 - 1 2 - - - 2 2 7 8 9 10 11 12 7 8 9 10 11 12 - -
101 - 101 102 - - - 102 102 107 108 109 110 111 112 107 108 109 110 111 112 - -
201 - 201 202 - - - 202 102 207 208 209 210 211 212 207 208 209 210 211 212 - -
301 - 301 302 - - - 302 102 307 308 309 310 311 312 307 308 309 310 311 312 - -
1