User's Manual
Table Of Contents
- Table of Contents
- List of Figures
- List of Tables
- Foreword
- FCC Requirements
- General Safety
- Revision History
- Patent Notification
- Chapter 1 Introduction
- Chapter 2 Preliminary Operations
- Chapter 3 Optimization/Calibration
- Optimization/Calibration - Introduction
- Isolate Span Lines/Connect LMF
- Preparing the LMF
- Using CDMA LMF
- Download the BTS
- CSM System Time/GPS and LFR/HSO Verification
- Test Equipment Set-up
- Test Set Calibration
- Bay Level Offset Calibration
- RFDS Set-up and Calibration
- BTS Redundancy/Alarm Testing
- BTS Alarms Testing
- Preliminary Operations: Overview
- Pre-Power-up Tests
- Initial Power-up Tests
- Chapter 4 Automated Acceptance Test Procedure
- Automated Acceptance Test Procedures - All-inclusive TX & RX
- TX Output Acceptance Tests: Introduction
- TX Spectral Purity Transmit Mask Acceptance Test
- TX Waveform Quality (rho) Acceptance Test
- TX Pilot Time Offset Acceptance Test
- TX Code Domain Power/Noise Floor Acceptance Test
- RX Frame Error Rate (FER) Acceptance Test
- Generate an ATP Report
- Chapter 5 Prepare to Leave the Site
- Chapter 6 Basic Troubleshooting
- Basic Troubleshooting Overview
- Troubleshooting: Installation
- Troubleshooting: Download
- Troubleshooting: Calibration
- Troubleshooting: Transmit ATP
- Troubleshooting: Receive ATP
- Troubleshooting: CSM Check-list
- C-CCP Backplane Troubleshooting
- Module Front Panel LED Indicators and Connectors
- Basic Troubleshooting - Span Control Link
- Appendix A Data Sheets
- Appendix B PN Offset/I & Q Offset Register Programming Information
- Appendix C FRU Optimization/ATP Test Matrix
- Appendix D BBX Gain Set Point vs. BTS Output
- Appendix E CDMA Operating Frequency
- Appendix F PCS Interface Setup for Manual Testing
- Appendix G VSWR
- Appendix H Download ROM Code
- Appendix I In-Service Calibration
- Appendix J GPIB Addresses
- Introduction
- HP437 Power Meter GPIB Address
- Gigatronics 8541C Power Meter GPIB Address
- Motorola CyberTest GPIB Address
- HP8935 Test Set GPIB Address
- Setting HP8921A and HP83236A/B GPIB Address
- Advantest R3465 GPIB Address
- RS232 GPIB Interface Box
- Advantest R3267 Spectrum Analyzer GPIB Address
- Agilent E4406A Transmitter Tester GPIB Address
- Index
Abbreviations and Acronyms68P09255A61-4
Aug 2002
1X SC 4812T BTS Optimization/ATP Software Release 2.16.1.x
FIELD TRIAL
1-7
Abbreviations and Acronyms
Table 1-1 identifies the equipment related abbreviations and acronyms
used in this manual.
Table 1-1: Abbreviations and Acronyms
Acronym Definition
AMR Alarm Monitor Reporting
ATP Acceptance Test Procedure
BBX Broadband Transceiver
BBX2 Broadband Transceiver, 2nd Generation supports
IS-95A/B
BBX-1X Broadband Transceiver, 3rd Generation supports
IS-95A/B and cdma2000 1X
BLO Bay Level Offset
BTS Base Transceiver Subsystem
CBSC Centralized Base Station Controller
CCD CDMA Clock Distribution
CDMA Code Division Multiple Access
CE Channel Element
CHI Concentration Highway Interface
CIO Combiner Input/Output
CLI Command Line Interface
CM Channel Module
CNEOMI Common Network Element Operation and
Maintenance Interface
CSM Clock Synchronization Manager
CSM-I Clock Synchronization Manager, 1st Generation
CSM card hardware version
CSM-II Clock Synchronization Manager, 2nd Generation
CSM card hardware version
DRDC Duplexer/RX Filter/Directional Coupler
EMI Electromagnetic Interference
EMPC Expansion Multicoupler Preselector Card
FRU Field Replaceable Unit
GLI Group Line Interface,
GLI2 Group Line Interface, 2nd Generation card
hardware version
GLI3 Group Line Interface, 3rd Generation card
hardware version for packet backhaul
GPS Global Positioning System
HSO High Stability Oscillator
HSOX High Stability Oscillator Expansion
I&Q In-phase and Quadrature
. . . continued on next page
1