User's Manual
Table Of Contents
- Table of Contents
- List of Figures
- List of Tables
- Foreword
- FCC Requirements
- General Safety
- Revision History
- Patent Notification
- Chapter 1 Introduction
- Chapter 2 Preliminary Operations
- Chapter 3 Optimization/Calibration
- Optimization/Calibration - Introduction
- Isolate Span Lines/Connect LMF
- Preparing the LMF
- Using CDMA LMF
- Download the BTS
- CSM System Time/GPS and LFR/HSO Verification
- Test Equipment Set-up
- Test Set Calibration
- Bay Level Offset Calibration
- RFDS Set-up and Calibration
- BTS Redundancy/Alarm Testing
- BTS Alarms Testing
- Preliminary Operations: Overview
- Pre-Power-up Tests
- Initial Power-up Tests
- Chapter 4 Automated Acceptance Test Procedure
- Automated Acceptance Test Procedures - All-inclusive TX & RX
- TX Output Acceptance Tests: Introduction
- TX Spectral Purity Transmit Mask Acceptance Test
- TX Waveform Quality (rho) Acceptance Test
- TX Pilot Time Offset Acceptance Test
- TX Code Domain Power/Noise Floor Acceptance Test
- RX Frame Error Rate (FER) Acceptance Test
- Generate an ATP Report
- Chapter 5 Prepare to Leave the Site
- Chapter 6 Basic Troubleshooting
- Basic Troubleshooting Overview
- Troubleshooting: Installation
- Troubleshooting: Download
- Troubleshooting: Calibration
- Troubleshooting: Transmit ATP
- Troubleshooting: Receive ATP
- Troubleshooting: CSM Check-list
- C-CCP Backplane Troubleshooting
- Module Front Panel LED Indicators and Connectors
- Basic Troubleshooting - Span Control Link
- Appendix A Data Sheets
- Appendix B PN Offset/I & Q Offset Register Programming Information
- Appendix C FRU Optimization/ATP Test Matrix
- Appendix D BBX Gain Set Point vs. BTS Output
- Appendix E CDMA Operating Frequency
- Appendix F PCS Interface Setup for Manual Testing
- Appendix G VSWR
- Appendix H Download ROM Code
- Appendix I In-Service Calibration
- Appendix J GPIB Addresses
- Introduction
- HP437 Power Meter GPIB Address
- Gigatronics 8541C Power Meter GPIB Address
- Motorola CyberTest GPIB Address
- HP8935 Test Set GPIB Address
- Setting HP8921A and HP83236A/B GPIB Address
- Advantest R3465 GPIB Address
- RS232 GPIB Interface Box
- Advantest R3267 Spectrum Analyzer GPIB Address
- Agilent E4406A Transmitter Tester GPIB Address
- Index
Table of Contents
68P09255A61-4
1X SC 4812T BTS Optimization/ATP Software Release 2.16.1.x
FIELD TRIAL
xv
Aug 2002
Table A-17: AMR CDI Alarm Input Verification A-17. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table B-1: PnMask I and PnMask Q Values for PilotPn B-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table C-1: When RF Optimization Is required on the BTS C-1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table C-2: When to Optimize Inter-frame Cabling C-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table C-3: SC 4812T BTS Optimization and ATP Test Matrix C-3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table D-1: BBX Gain Set Point vs. Actual BTS Output (in dBm) D-1. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table E-1: 1900 MHz TX and RX Frequency vs. Channel E-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table E-2: 800 MHz TX and RX Frequency vs. Channel E-4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table E-3: 1700 MHz TX and RX Frequency vs. Channel (Korean Bands) E-7. . . . . . . . . . . . . . . . . . .
Table F-1: System Connectivity F-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table F-2: Manual Cable Calibration Test Equipment Setup (using the HP PCS Interface) F-3. . . . . .
Table F-3: HP PCS Interface Test Equipment Setup for Manual Testing F-7. . . . . . . . . . . . . . . . . . . . . .
Table F-4: Procedure for Calibrating Test Cable Setup Using Advantest R3465 F-8. . . . . . . . . . . . . . .
Table G-1: VSWR Measurement Procedure - HP Test Set G-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table G-2: VSWR Measurement Procedure - Advantest Test Set G-4. . . . . . . . . . . . . . . . . . . . . . . . . . .
Table H-1: Download ROM Code H-1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table I-1: HP8921A Power Delta Calibration Procedure I-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table I-2: Advantest Power Delta Calibration Procedure I-4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table I-3: HP8935 Power Delta Calibration Procedure I-7. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table I-4: Agilent E4406A Power Delta Calibration Procedure I-9. . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table I-5: In-Service Calibration I-15. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table J-1: Verify and/or Change HP437 Power Meter GPIB Address J-1. . . . . . . . . . . . . . . . . . . . . . . .
Table J-2: Verify and/or Change Gigatronics 8541C Power Meter GPIB Address J-2. . . . . . . . . . . . . .
Table J-3: Verify and/or Change Motorola CyberTest GPIB Address J-3. . . . . . . . . . . . . . . . . . . . . . . . .
Table J-4: Verify and/or Change HP8935 GPIB Address J-4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table J-5: Verify and/or Change HP8921A and HP83236A GPIB Addresses J-5. . . . . . . . . . . . . . . . . .
Table J-6: Verify and/or Change Advantest R3465 GPIB Address J-7. . . . . . . . . . . . . . . . . . . . . . . . . . .
Table J-7: Verify and Change Advantest R3267 GPIB Address J-9. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table J-8: Verify and Change Agilent E4406A GPIB Address J-11. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Table J-9: Verify and Change Agilent E4432B GPIB Address J-12. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .