User's Manual
Table Of Contents
- Table of Contents
- List of Figures
- List of Tables
- Foreword
- FCC Requirements
- General Safety
- Revision History
- Patent Notification
- Chapter 1 Introduction
- Chapter 2 Preliminary Operations
- Chapter 3 Optimization/Calibration
- Optimization/Calibration - Introduction
- Isolate Span Lines/Connect LMF
- Preparing the LMF
- Using CDMA LMF
- Download the BTS
- CSM System Time/GPS and LFR/HSO Verification
- Test Equipment Set-up
- Test Set Calibration
- Bay Level Offset Calibration
- RFDS Set-up and Calibration
- BTS Redundancy/Alarm Testing
- BTS Alarms Testing
- Preliminary Operations: Overview
- Pre-Power-up Tests
- Initial Power-up Tests
- Chapter 4 Automated Acceptance Test Procedure
- Automated Acceptance Test Procedures - All-inclusive TX & RX
- TX Output Acceptance Tests: Introduction
- TX Spectral Purity Transmit Mask Acceptance Test
- TX Waveform Quality (rho) Acceptance Test
- TX Pilot Time Offset Acceptance Test
- TX Code Domain Power/Noise Floor Acceptance Test
- RX Frame Error Rate (FER) Acceptance Test
- Generate an ATP Report
- Chapter 5 Prepare to Leave the Site
- Chapter 6 Basic Troubleshooting
- Basic Troubleshooting Overview
- Troubleshooting: Installation
- Troubleshooting: Download
- Troubleshooting: Calibration
- Troubleshooting: Transmit ATP
- Troubleshooting: Receive ATP
- Troubleshooting: CSM Check-list
- C-CCP Backplane Troubleshooting
- Module Front Panel LED Indicators and Connectors
- Basic Troubleshooting - Span Control Link
- Appendix A Data Sheets
- Appendix B PN Offset/I & Q Offset Register Programming Information
- Appendix C FRU Optimization/ATP Test Matrix
- Appendix D BBX Gain Set Point vs. BTS Output
- Appendix E CDMA Operating Frequency
- Appendix F PCS Interface Setup for Manual Testing
- Appendix G VSWR
- Appendix H Download ROM Code
- Appendix I In-Service Calibration
- Appendix J GPIB Addresses
- Introduction
- HP437 Power Meter GPIB Address
- Gigatronics 8541C Power Meter GPIB Address
- Motorola CyberTest GPIB Address
- HP8935 Test Set GPIB Address
- Setting HP8921A and HP83236A/B GPIB Address
- Advantest R3465 GPIB Address
- RS232 GPIB Interface Box
- Advantest R3267 Spectrum Analyzer GPIB Address
- Agilent E4406A Transmitter Tester GPIB Address
- Index
Table of Contents
68P09255A61-4
1X SC 4812T BTS Optimization/ATP Software Release 2.16.1.x
FIELD TRIAL
x
Aug 2002
Figure 3-17: Typical TX ATP Setup with Directional Coupler 3-55. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 3-18: Typical RX ATP Setup with Directional Coupler 3-56. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 3-19: Agilent E4406A Self-alignment 3-61. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 3-20: Calibrating Test Equipment Setup for TX BLO and TX ATP Tests 3-64. . . . . . . . . . . . . . . .
Figure 3-21: Calibrating Test Equipment Setup for RX ATP Test 3-65. . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 3-22: SC 4812T C-CCP Shelf 3-90. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 3-23: -48 V BTS Power Conversion Shelf 3-91. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 3-24: +27 V BTS C-CCP Fan Modules 3-92. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 3-25: -48 V BTS C-CCP and Power Conversion Shelf Fan Modules 3-93. . . . . . . . . . . . . . . . . .
Figure 3-26: +27 V SC 4812T Starter Frame I/O Plate 3-96. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 3-27: Alarm Connector Location and Connector Pin Numbering 3-100. . . . . . . . . . . . . . . . . . . . . .
Figure 3-28: AMR Connector Pin Numbering 3-101. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 4-1: TX Mask Verification Spectrum Analyzer Display 4-8. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 4-2: Code Domain Power and Noise Floor Levels 4-12. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 5-1: Site and Span I/O Boards T1 Span Connections 5-3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 5-2: MGLI2/GLI2 MMI Port Connection 5-5. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 6-1: CSM Front Panel Indicators & Monitor Ports 6-21. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 6-2: GLI2 Front Panel 6-24. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 6-3: GLI3 Front Panel 6-25. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 6-4: MCC Front Panel 6-27. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure 6-5: MGLI/GLI Board MMI Connection Detail 6-29. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure E-1: North American PCS 1900 MHz Frequency Spectrum E-1. . . . . . . . . . . . . . . . . . . . . . . . . .
Figure E-2: North American Cellular Telephone System Frequency Spectrum E-4. . . . . . . . . . . . . . . .
Figure E-3: 1700 MHz PCS Frequency Spectrum E-6. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure F-1: Calibrating Test Setup Components F-6. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure F-2: Cable Calibration using Advantest R3465 F-10. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure G-1: Manual VSWR Test Setup Using HP8921 Test Set (1700/1900 MHz) G-3. . . . . . . . . . . . .
Figure G-2: Manual VSWR Test Setup Using HP8921 Test Set (800 MHz) G-4. . . . . . . . . . . . . . . . . . .
Figure G-3: Manual VSWR Test Setup Using Advantest R3465 G-6. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure I-1: Delta Calibration Setup - HP8921A to HP437B I-3. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure I-2: Delta Calibration Setup - HP8921A to HP8921A I-4. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure I-3: Delta Calibration Setup - R3561L to HP437B I-6. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure I-4: Delta Calibration Setup - R3561L to R3465 I-6. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure I-5: Delta Calibration Setup - HP8935 to HP437B I-8. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure I-6: Delta Calibration Setup - HP8935 to HP8935 I-8. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure I-7: Delta Calibration Setup - Agilent E4432B to HP437 I-11. . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure I-8: Delta Calibration Setup - Agilent E4432B to Agilent E4406A I-11. . . . . . . . . . . . . . . . . . . . .
Figure I-9: Optimization/ATP Test Setup Using RFDS I-13. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure I-10: IS-95 A/B/C Optimization/ATP Test Setup Using RFDS I-14. . . . . . . . . . . . . . . . . . . . . . . . .
Figure J-1: HP437 Power Meter J-1. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .
Figure J-2: Gigatronics 8541C Power Meter Detail J-2. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . .