User's Manual

Subscriber Unit (SU) Installation and Cabling – continued
JAN 2002
6-17
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
DRAFT
Procedure to Install SU Cabling
Table 6-11 gives the procedure to install the SU cabling on a MicroCell
unit.
Table 6-12: Procedure to Install the SU Cabling
Step Action
1 Attach one end of the SU RF cable (cable P) to the SU 1 connector on the SU. Attach the other
end of cable P to the SU RF connector on the unit. Refer to Figure 6-11.
2 Use the 5/16–in. SMA breakaway wrench to tighten the SMA connectors on the SU RF cable.
3 Attach the free end of the SU Digital cable (cable Q) to the SU DIGITAL connector on the unit.
Refer to Figure 6-11. Hand tighten the SU Digital connector (you will hear soft clicks, this is
normal). When the red line on the connector on the unit is covered, the connection is complete.
Figure 6-11: Attaching SU Cables to Unit
SU DIGITAL CABLE (CABLE Q)
SU RF CABLE (CABLE P)
6