User's Manual

Attaching Optional Installation Handles to the Unit

DRAFT

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

JAN 2002

6-6

Objective

The objective of this procedure is to attach the installation handles to the

unit. The location for the handles is shown in Figure 6-5. The handles

should be used when lifting or carrying the unit.

Installation handles are available with installation kit

#SGLN5754

NOTE

Required Tools and Materials

Tools

Attaching the installation handles to the unit requires:

 T30 Torx tamper bit

 Torque driver wrench, 1/4–in. hex female drive, 0–10 N–M

Motorola parts

Table 6-2 lists the parts necessary to do this procedure.

Table 6-2: Installation Handle Kit

Quantity Part Number Description

2 0387541C08 Screws M6x25

2 0387541C09 Screws M6x35

2 5588425C01 Handle

Procedure to Attach the

Handles to the Unit

Attach the installation handles to the unit by following the procedures in

Table 6-3 and the information in Figure 6-5.

Table 6-3: Procedure to Attach the Installation Handles

Step Action

1 Hold one handle in position and start the upper screw. See Figure 6-5.

2 Start the lower screw.

3 Use a T30 Torx tamper bit to torque the two M6 screws to 5.0 N–m.

4 Repeat steps 1–3 for the other handle.