Manualshelf

User's Manual

ManualsBrandsNokia Solutions and Networks ManualsElectronicsSC300 1X Microcell @ 800 MHz
71727374757677787980
Attaching Back Fin Cover to Unit
JAN 2002
6-5
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
DRAFT
Objective
The objective of this procedure is to attach the back fin cover to the
MicroCell unit. The front fin cover is mounted to the unit after the unit
is mounted to the mounting bracket.
When to Use the Fin Covers
You must always use fin covers in an indoor application.
Procedure to Install Back Fin
Cover to Unit
Attach the back fin cover to the unit by following the procedures in
Table 6-1 and the information in Figure 6-4.
Table 6-1: Procedure to Install Back Fin Cover to Unit
Step Action
1 Install back fin cover prior to placing unit on the mounting bracket.
2 Center fin cover on the fins of the unit. See Figure 6-4 for snap locations.
3 Align snap with center tab on fins.
4 Push fin cover into place.
Figure 6-4: Attaching Back Fin Cover to Unit
LOCATION OF SNAPS TO ATTACH
FIN COVER TO UNIT
MICROCELL FINS
6