User's Manual
Attaching the Surge Suppressor to Mounting Bracket
DRAFT
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
JAN 2002
5-6
Objective
The objective of this procedure is to attach the optional Primary Surge
Suppressor to the mounting bracket. This procedure applies to mounting
brackets that are attached to a rack, wall or pole.
You must attach the Primary Surge Suppressor to the
mounting bracket before you install the unit cabling.
IMPORTANT
*
Background
The following procedures should be followed in order to mount the
surge suppressor to the mounting bracket. The unit attaches to the
mounting bracket with three (3) M6 screws.
Required Tools and Equipment
The following tools and materials are required to attach the unit to the
mounting bracket.
Torque driver wrench, 1/4–in. hex female drive, 0–10 N–M
T30 Torx tamper bit
Three M6X19 screws (Motorola Part Number 0387541C03)
Procedure to Attach the Surge
Suppressor to the Mounting
Bracket
Use the procedure in Table 5-1 to attach the surge suppressor to the
mounting bracket. Refer to Figure 5-5.
Table 5-1: Procedure to Attach the Surge Suppressor to the Mounting Bracket
Step Action
1 Lift the unit and place it on the mounting bracket by aligning the bracket’s upper arms into the
rectangular cutouts in the mounting tabs. The unit may need to be raised up slightly so that the
lower bracket flange does not contact the unit’s lower surface.
2 Use a T30 Torx tamper bit to start, but not tighten, all three screws in the location shown in
Figure 5-5.
3 Use a T30 Torx tamper bit to torque the three mounting screws to 5.0 N–M.
5