User's Manual

Power, Ground, and Battery Cabling for Sites Equipped with

Customer–Supplied Site I/O Interface

– continued

DRAFT

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

JAN 2002

4-14

Figure 4-7: AC Installation Box

AC POWER CABLE

CONNECTOR

NOTE: Shown with door removed for clarity

1–IN AC

CONDUIT

TO MICROCELL

LOCATION

CUSTOMER

AC INPUT

TERMINAL

BLOCK

LINE

NEUTRAL

GROUND

CUSTOMER POWER

CONNECTIONS

Table 4-19: Procedure to Install DC Input Cable(s)

Step Action

1 Connect the loose wires of cable U (DC input cable) to the customer defined DC power source.

Refer to Table 4-14 for wiring information.

2 Verify all connections of cable U with an multimeter prior to routing the cable.

3 Route cable U from the DC power supply to the unit location.