User's Manual
MIB Cabling for Multi–Unit Logical BTS Configurations
DRAFT
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
JAN 2002
6-34
Overview
The objective of this procedure is to attach the MIB cabling for a
multi–unit logical BTS configuration.
Cable Labels
The cable designations are referenced in Table 4–1 in the “Cable
Descriptions” procedure in Chapter 4.
Required Tools and Equipment
Motorola parts
The following terminators in Table 6-23 are necessary to do this
procedure for a single–unit installation and are shipped with the unit:
Table 6-23: MIB Terminators
Quantity Part Number Description
3 3009865S04 Dust cap
1 3009865S02 Terminator, MIB (Microcell)
Motorola kits for multi–unit installations
Table 6-24 through Table 6-31 give the Motorola kit numbers, cable
descriptions and part numbers for the Motorola kits required to perform
a multi–unit installation. Several kits are available depending upon the
carrier installation.
Table 6-24: MicroCell Expansion Kit for Units 1 to 2 Short MIB A (Cubicle) – T448B
Cable Qty. Motorola Part
Number
Description
n/a 2 5882106P01 50 Ohm Antenna Terminator
A 1 3087701C02 Ground cable, 8 -AWG, insulated copper wire. Requires one ring lug
connector.
K 1 3087707C09 MIB A cable (short, 1m; micro)
Table 6-25: Microcell Expansion Kit for Units 1 to 2 Long MIB A (Non–Cubicle) – T448A
Cable Qty. Motorola Part
Number
Description
n/a 2 5882106P01 50 Ohm Antenna Terminator
A 1 3087701C02 Ground cable, 8 -AWG, insulated copper wire. Requires one ring lug
connector.
E 1 3087707C03 MIB A cable (current, 2m; micro)
6