User's Manual

Prepare to Leave the Site – continued

JAN 2002

7-93

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

DRAFT

Replace Diagnostic Access

Cover

Use a T20 Torx tamper bit to tighten the two tamper–resistant M4

screws holding the cover. Torque to 10 in–lb. Refer to Figure 7-38.

Figure 7-38: How To Replace The Diagnostic Access Cover

SCREWS IN DIAGNOSTIC

ACCESS COVER ARE CAPTIVE

Replace Solar Cover

Replace the solar cover. Refer to the “Powering on Unit and Mounting

the Solar Cover” procedure in Chapter 5.