User's Manual

Prepare to Leave the Site – continued

DRAFT

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

JAN 2002

7-92

Table 7-53: Procedure to Bring BTS into Service

Step Action

1 On the CDMA LMF, select the MAWI.

2 Click on Device from the menu bar.

3 Click on Enable from the Device menu. A status report window is displayed.

4 Click Cancel to close the transceiver parameters window, if applicable.

5 Click OK to close the status report window.

The selected devices that successfully change to INS change color to green.

Terminate LMF

Session/Remove Terminal

Perform the procedure in Table 7-54 to terminate the LMF session and

remove the CDMA LMF computer.

Table 7-54: Procedure to Remove LMF

Step Action

! CAUTION

Do not power down the CDMA LMF terminal without performing the procedure below.

Corrupted/lost data files may result.

1 Log out of all BTS sessions and exit CDMA LMF by clicking on the File selection in the menu bar

and selecting Exit from the File menu list.

2 Click Yes in the Confirm Logout pop–up message which appears.

3 In the Windows Task Bar, click Start and select Shutdown.

4 Click Yes when the Shut Down Windows message appears.

5 Wait for the system to shut down and the screen to go blank.

6 Disconnect the CDMA LMF terminal serial cable from the BTS.

7 Disconnect the CDMA LMF terminal serial port, the RS–232–IEEE488 converter and the GPIB

cables as required for equipment transport.