User's Manual

Copy LMF CAL File to CBSC – continued

DRAFT

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

JAN 2002

7-90

Procedure to Copy CAL Files

from Diskette to the CBSC

Follow the procedures in Table 7-50 to copy CAL file from a diskette to

the CBSC.

Table 7-50: Procedure to Copy CAL Files from Diskette to the CBSC

Step Action

1 Log in to the CBSC on the OMC–R Unix workstation using your account name and password.

2 Place your diskette containing calibration file(s) in the workstation diskette drive.

3 Type in eject –q and press the Enter key.

4 Type in mount and press the Enter key.

NOTE

 Check to see that the message floppy/no_name is displayed on the last line.

 If the eject command was previously entered, floppy/no_name will be appended with a

number. Use the explicit floppy/no_name reference displayed.

5 Type in cd /floppy/no_name and press the Enter key.

6 Type in ls –lia and press the Enter key. Verify that the bts–#.cal file is on the diskette.

7 Type in cd and press the Enter key.

8 Type in pwd and press the Enter key. Verify you are in your home directory (/home/<name>).

9 With Solaris versions of Unix, create a Unix–formatted version of the bts–#.cal file in your home

directory by entering the following command:

dos2unix /floppy/no_name/bts–#.cal bts–#.cal and press the Enter key

(where # is BTS number).

NOTE

Other versions of Unix do not support the dos2unix command. In these cases, use the Unix cp

(copy) command. The copied files will contain DOS line feed characters which must be edited out

with a Unix text editor.

10 Type in ls –l *.cal and press the Enter key. Verify the cal files have been copied.

11 Type in eject and press the Enter key.

12 Remove the diskette from the workstation.