User's Manual

RX Acceptance Tests

DRAFT

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

JAN 2002

7-84

Objective

This procedure assumes that the site specific CDF file is in the

wlmf\cdma\bts–# folder.

Prerequisites

You must successfully complete all the procedures outlined in previous

chapters before you attempt to run an ATP.

Procedure to Run RX ATP Test

Refer to Table 7-47 to perform an RX ATP test. This procedure assumes

that the site specific CDF file is in the wlmf\cdma\bts–# folder.

Table 7-47: Procedure to Run RX ATP Test

Step Action

1 Set up test equipment per Figure 7-35, Figure 7-36, or Figure 7-37.

2 Terminate diversity RX antenna inputs on the unit.

3 Enter the following commands to run the RX Acceptance Tests.

– Select the MAWI.

– Select Tests>ALL RX.

NOTE

The LMF refers to the antennas as Main and Diversity. The Main is Antenna B and the Diversity

is Antenna A.

NOTE

Select Both in the RX Branch pick list if a diversity antenna is used.