User's Manual

BTS Preparation – continued

DRAFT

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

JAN 2002

7-4

Procedure to Remove

Diagnostic Access Cover

The screws are captivated. Do not attempt to remove them

from the cover.

NOTE

Table 7-1: Procedure for Removing Diagnostic Access Cover

Step Action

1 Using a T20 Torx tamper bit, loosen the two tamper resistant M4 screws holding the cover. See

Figure 7-4.

2 Gently tap the cover to loosen if required.

3 Remove the cover and set inside a secure place.

NOTE

The 19 MHz and 2 SEC connectors should not be terminated with a 50 ohm terminator.

Figure 7-4: How To Remove The Diagnostic Access Cover

SCREWS IN DIAGNOSTIC

ACCESS COVER ARE CAPTIVE