User's Manual

BTS Preparation

DRAFT

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

JAN 2002

7-2

Overview

The purpose of this procedure is to prepare the BTS for the ATP. This

procedure consists of:

1. Solar Cover Removal

2. BTS Power Up

3. Diagnostic Access Cover Removal

Required Tools and Equipment

The following tools and materials are necessary to do this procedure:

 Torque driver wrench, 1/4–in. hex female drive, 0–10 N–M

 T20 Torx tamper bit

Procedure to Remove the Solar

Cover

If you did not mount the solar cover during the unit installation, then this

procedure is not necessary.

Remove the four captive screws (two on each side) that hold the front

solar cover. Refer to Figure 7-1.

Figure 7-1: Front Solar Cover

FRONT COVER

CAPTIVE SCREWS

BTS Power Up

Figure 7-2 shows the location of the AC power breakers inside the

optional Primary Surge Suppressor. The AC breakers must be closed

before you power up the MicroCell unit.

Figure 7-3 shows the location of the AC and DC Power breakers on the

unit. Push both the AC and DC breakers in to power up the unit.