User's Manual

GPIB Addresses – continued
DRAFT
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
JAN 2002
7-44
Verify and Set Advantest R3465
GPIB Address
Table 7-25 describes the steps to verify and, if necessary, change the
GPIB address for the Advantest R3465.
Table 7-25: Verify and/or Change Advantest R3465 GPIB Address
Step Action
1 Perform the following procedure to verify that the GPIB address is set correctly:
– Press SHIFT then PRESET (see Figure 7-21).
– Press LCL.
– Press the GPIB and Others CRT menu key to view the current address.
2 If the current GPIB address is not set to 18, perform the following to change it:
– Turn the vernier knob as required to select 18.
– Press the vernier knob to set the address.
3 To return to normal operation, press Shift and Preset.
Figure 7-21: R3465 Communications Test Set
BNC
“T”
REF UNLOCK
EVEN
SEC/SYNC IN
CDMA
TIME BASE IN
POWER
OFF
ON
REF FW00337
LCL Shift Preset
GPIB and others
Vernier
Knob
7