User's Manual

GPIB Addresses – continued

JAN 2002

7-43

SC300 1X BTS Hardware Installation, ATP, and FRU Procedures

DRAFT

Verify and Set the HP8921A

and HP83236A/B GPIB

Addresses

Follow the procedure in Table 7-24 to verify and, if necessary, change

the HP8921A/HP83236A GPIB addresses.

Table 7-24: Verify and/or Change HP8921A and HP83236A GPIB Addresses

Step Action

1 To verify that the GPIB addresses are set correctly, press Shift and LOCAL on the HP8921A (refer to

Figure 7-20). The current HP–IB address is displayed at the top of the screen.

NOTE

HP–IB is the same as GPIB.

2 If the current HP–IB address is not set to 18, perform the following to change it:

– Turn the Cursor Control knob to move the cursor to More and press the knob to select the field.

– Turn the Cursor Control knob to move the cursor to I/O Config and press the knob to select the

field.

– Turn the Cursor Control knob to move the cursor to Adrs and press the knob to select the field.

– Turn the Cursor Control knob to change the HP–IB address to 18 and press the knob to set the

address.

– Press Shift and Preset to return to normal operation.

3 To set the HP83236A (or B) PCS Interface GPIB address=19, set the dip switches as follows:

– A1=1, A2=1, A3=0, A4=0, A5=1, HP–IB/Ser = 1

Preset

Cursor Control

Shift

Local

Figure 7-20: HP8921A and HP83236A/B