User's Manual

Verify and Set Span Line Settings – continued
DRAFT
SC300 1X BTS Hardware Installation, ATP, and FRU Procedures
JAN 2002
7-38
Table 7-19: Procedure to Verify and Set Span Line Settings
Step Action
5 If the span line settings are not the same for spans A and B, then enter the SPAN_CONFIG
command for span A. Refer to the SPAN_CONFIG parameters in Table 7-20.
SC300>span_config <span> <span type> <link speed> <span
equalization> <LAPD channel>
The SPAN_CONFIG parameters shown below are an example and may not be applicable to your
configuration.
SC300>span_config a 5 64 0 0
The system will return to the SC300> prompt:
6 Enter the SPAN_CONFIG command for span B. Use the same parameters that you used in step
5. Refer to the SPAN_CONFIG parameters in Table 7-20.
SC300>span_config <span> <span type> <link speed> <span
equalization> <LAPD channel>
The SPAN_CONFIG parameters shown below are an example and may not be applicable to your
configuration.
SC300>span_config b 5 64 0 0
The system will return to the SC300> prompt:
7 Enter the following command at the SC300> prompt to verify the changes to the span A settings:
SC300>span_config a
The system will display the following typical output.
Span A data:
Span type: 5 – T1_2 (B8ZS, DS1 AT&T ESF 4 to 1 packing, 64K link)
Link Speed: 64K
Span EQ: 0 – T1_6 (T1, J1:longhaul, same as choice 10)
LAPD slot: 0
8 Enter the following command at the SC300> prompt to verify the changes to the span B settings:
SC300>span_config b
The system will display the following typical output.
Span B data:
Span type: 5 – T1_2 (B8ZS, DS1 AT&T ESF 4 to 1 packing, 64K link)
Link Speed: 64K
Span EQ: 0 – T1_6 (T1, J1:longhaul, same as choice 10)
LAPD slot: 0
7